Klarstein 10030556 Mode D'emploi page 9

Step 1
Attach the legs
1. Align the two holes of the legs (D) with the two
holes on the metal strips located underneath
the lower charcoal ring.
2. Place screw (F) in aligned holes and tighten
using a Phillips head screwdriver.
3. Repeat steps 1 and 2 for remaining legs.
Step 2
Attach the "U" brackets
1. Align the hole at the top of the "u" bracket
(I) with the hole in the center of the cooking
cylinder and slide one screw (F) through the
aligned holes.
2. Place washer
nut (G)
the inside of the cooking cylinder. Tighten nut
(G) using Crescent wrench and Phillips head
screwdriver.
3. Repeat steps 1 and 2 for the remaining "u"
brackets.
9
Assembly
(H) and
over screw
(F)
(F)
on
(D)
(H)
(G)
(I)