Lixx Storage Program - GRAUPNER SJ ULTRA QUICK 70 Instructions D'utilisation

Note: this function is only available for the LiXX battery type.
When LiXX batteries are stored for long periods they must not be in the fully charged or discharged state, as this causes them to lose capacity and may
even ruin them. The STORE charge program should be used to prepare batteries for optimum storage; this charges or discharges the battery until it is
at about 70% of full capacity.
START>1<
LiPo
MODE
START-2 SEC
Charge
START...
Press the MODE  button to move to the STORE menu. A brief press on the CHANGE / START button selects the line showing the final charge voltage
(in this case 4.00 V); the value can be altered using  or . A further brief press of CHANGE / START saves your setting.
B a t t e r y Setting range
type
LiIon 3.6 - 4.1 V
LiPo 3.7 - 4.2 V
LiFe 3.3 - 3.6 V
Hold CHANGE / START pressed in for at least two seconds to start the storage function. If the voltage of the battery connected to the charger is lower
than the set storage voltage, the charger charges the battery; if the voltage is higher, the charger discharges the battery at the balance current (max. 300
mA) until the set voltage is reached.
36
15. LiXX storgae program
BATT >1<
SETUP
MODE
Factory setting
3.9 V
4.0 V
3.5 V
STORE >< USER ><
4.00 V/C SETUP
MODE
START-2 SEC
STORE
START...
VIEW ><
-DATA-
MODE
Manual ULTRA QUICK 70
MODE