Using The Charger For The First Time - GRAUPNER SJ ULTRA QUICK 70 Instructions D'utilisation

Connect the charger's 100 - 240 V AC input to a mains wall socket, or connect the charger's DC input to a 12 V car battery or an 11...15 V DC mains
PSU with a capacity of at least 12 A.
WARNING: Never connect both inputs at the same time!
The charger plays a welcome melody and shows the last selected battery memory in the display.
The ULTRA QUICK 70 is now ready for use. The charger is controlled using four buttons.
Button Description
CHANGE / START selection / start charging process
 (+) INC
up / increase value

(-) DEC down / decrease value

next
MODE
First press the CHANGE button and  or  to select a suitable battery memory (see table). If you have not yet programmed a suitable battery memory,
press the  button to move to the BATT -SETUP- screen (see Fig. 11), and set up the battery memory to suit your requirements: press CHANGE to select
the desired parameter, which then starts flashing. The parameter can now be adjusted using the  or  button; press CHANGE again to save the new
values, and the flashing ceases. You can switch between all the parameters to be changed using the  or  button.
Memory 0
NO.
Battery type NiMH
CELLS 6
Capacity 4200 mAh 3600 mAh
Current 6 A
Safety time 60
Delta peak 8 mV/C
Trickle auto
Note: it is only possible to program the currently active memory.
32

10. Using the charger for the first time

1 2 3
NiMH NiMH RTU NiMH RTU
6 8 4
2000 mAh 2000 mAh
4 A 2 A 2 A
45 60 60
8 mV/C 5 mV/C 5 mV/C
auto auto auto
4 5
LiFe LiPo LiPo
2 2
1800 mAh 6800 mAh 3000 mAh
1.8 A 6 A 3 A
120 120 120
x x
x x
6 7 8
LiPo LiPo
2 2 3
1500 mAh 4000 mAh
1.5 A 4 A
120 120
x x x
x x x
Manual ULTRA QUICK 70
9
LiIon
2
1500 mAh
1.5 A
120
x
x