JB Systems DJ-kontroL 2 Mode D'emploi page 9

ENGLISH
 Store a cue point: when no cue point is stored, the button is dark  press the CUE-button to store
the desired cue point. (cue points are automatically re-called when you load the track again)
 Play from a cue point: when a cue point is stored, the button is lit  press the CUE-button to start
playback immediately from the stored cue point.
 Delete a cue point: press the CUE+SHIFT buttons together  the stored cue point will be deleted.
32. SHIFT button: used to activate "extra functions" on some buttons. The extra function are usually written
in the grey zone under the buttons.
33. EFFECT ON/OFF button: used to switch the selected effect on/off.
34. EFFECT SELECT button: used to select one of the available effects.
35. PARAMETER1 knob: different functions available:
 Turn PARAMETER knob: adjust the parameter 1 of the selected effect.
 Turn PARAMETER knob while SHIFT is pressed: to adjust the frequency of the filter effect.
36. PARAMETER2 knob: different functions available:
 Turn PARAMETER knob: adjust the parameter 2 of the selected effect.
 Turn PARAMETER knob while SHIFT is pressed: to adjust the tonal pitch of the music.
FUNCTIONS (REAR)
37. USB connection: B-type USB-connector. Please use the supplied USB cable to connect the controller
to your computer.
Remark: if you are using a USB hub, make sure it is a powered hub. Otherwise you may experience
unexpected problems.
38. MASTER output: analog stereo output, used to connect your audio amplifier or amplified loudspeakers.
39. POWER ADAPTER input: used to connect the supplied 5Vdc power adapter.
Remark: the controller will also work without the power adapter, however in this case power is drawn
from the USB-port of your computer. In some cases, especially on portable computers, the provided
power is not enough. Please use the supplied power adapter to avoid instability under certain conditions.
®
JB SYSTEMS 7/50
USER MANUAL
DJ-KONTROL 2