Krick Florida Mode D'emploi page 38

Now make the handrails. First of all make the
bending templates.
There is one for the handrails next to the sky-
light and one for the handrail at the stern.
Fig. bending templates
Glue parts 8.8 - 8.10 and 8.11 - 8.13 to each
other. Pay attention to the resulting recess so
that the flat brass tube can be inserted on
edge.
Push the set collar part 8.23 onto the flat brass
tube at the end and clamp it firmly.
The collar serves as a stop during bending.
Fig. bent handrails
Bend the handrails one after the other.
It is necessary to carefully re-bend the hand-
rails by hand without template, because the
bends open.
Slightly bend the two handrails next to the
skylight in longitudinal direction according to
the deck contour.
The handrails can now be painted.
Status April 2020
Fig. handrails
Assemble the tank nozzle from parts 8.16 -
8.18.
Fig. parts for tank nozzle
Fig. tank nozzle
Sand and paint the tank nozzle.
Finally, make the exhaust pipes. Glue parts
8.19 and 8.20 together.
Fig. exhaust pipes
Seite 16
8.16
8.17
8.18
8.19
8.20
©
Krick Modelltechnik, Knittlingen, Germany