Krick Florida Mode D'emploi page 37

The skylight is made from parts 7.26 to 7.29
7.26
7.27
7.29
Fig. parts for the skylight
Glue the frame part 7.27 on the support 7.26.
Fig. finished frame
Now the frame can be painted.
Glue the hinge part 7.29 to the side with the
flattening.
Fig. window ready with hinge
Glue the window pane part 7.28 into the frame.
Best suited for this is RC Modellers Canopy
Glue, Best. No. 44126.
This glue dries colourlessly transparent.
Stage 8, Front screen, hand rails, cleats
etc., parts 8.1 - 8.24
Grind the frame of the windscreen 8.2. No
sanding marks should be visible on the side to
be painted, so use very fine 320 - 400 grade
sandpaper. The adhesive side may be roug-
her.
Status April 2020
7.28
Fig. window frame
Use a soft board as a mounting aid for the
windscreens.
Remove the protective film from one side of
the windscreen 8.1. Leave the protective film
on the other side for safety.
Fix the windscreen to the board with pins.
Fig. Wind shield fixed with pins
Paint the frame and let it dry well.
Apply a thin layer of glue to the underside of
the frame. You can also use RC Modellers
Canopy Glue, Order No. 44126
Now carefully slide the frame over the pins on
the glass. Gently press on.
Remove any swollen adhesive from the edge
with the tip of a knife. Weigh the frame down
with weights and let it dry.
Fig. windshield
After drying, remove the windscreen from the
building board. Now you can also remove the
protective foil on the back.
Seite 15 ©
Krick Modelltechnik, Knittlingen, Germany