ADE Vanessa Mode D'emploi page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
Thank you for your decision to purchase this high quality body analyser scale. Please
peruse read this instruction manual prior to first start up and keep this user instruction
careful so as to have this information on hand whenever it is needed.
1. How does the body analyser work?
Through this new revolutionary scale, you will be able to get information about your body
composition with reference to your weight, body fat %, body water %, muscle mass %,
and bone mass kg. First of all, you have to enter once your personal data like body
height, age, gender as well as your activity level under your selected personal memory
location. Afterwards a measurement is as simple as on a normal bathroom scale. You
have only to push your personal memory location, step on the scale and within a few
seconds, your measured values will be indicated. The analysis is based on the
measurement of the body's electrical resistance. A low, safe electrical signal passes
freely through fluids contained in lean tissue, such as muscle and blood, but meets
resistance passing through fat tissue. The body analyser accurately measures the
resistance and with reference to your personal data use it to calculate elements of body
composition.
2. How to use
If possible, the measurement should be done undressed but always barefoot.
By nature, a body is subject of fluctuations (for example loss of water after taking
exercise or after a sauna visit, after a meal, etc.). To enable comparable readings it is
important to take the measurements as possible always under the same conditions.
In order to ensure that the results of analysis are accurate and consistent, please keep
the measurement conditions constant always at the same daytime. In the morning,
directly after you've woken up, your body will be dehydrated and also the majority of fluid
will be stored in the central trunk area. This means that the resistance is relatively high
because of the poor conductivity in the body. By intensify moving during the day
progresses the fluid becomes more evenly distributed through the limbs and increasing
the accuracy of the readings. To get a realistic result it is important to take your readings
at the same time and under the same conditions every day. The easiest way to stick the
rule, measure always in the morning, 15 minutes after you've got up, either before or
after you've gone to the bathroom.
In spite of a very low elec trical signa l, this body analyser is not suitable for persons
with hea rt pacemaker or other elec tronic medica l implants! There is no risk for
persons with none electronic implant for instance a titanium plate in the knee. However,
metal conducts the electric current extremely well and therefore the scale implicates the
body fat value "beautified" – means the actual body fat value is higher as indicated.
However, tendencies may be determined as well.
2
7. Error Messages
„EEEE"
=
Overload - The weight exceeds the maximum capacity of 150 kg.
Please immediately remove the critical load to avoid load cell damage.
„Err2"
=
Incorrect weighing / measuring process - For example, the scale is
placed unstable, you do not remain stationary on the weighing platform
or if body fat is less than 5% or higher than 75%.
„Lo"
=
Batteries are used up - Please replace the batteries with the intended
type (2 x CR 2032).
8. Technical Data
Capacity x graduation:
max. 150 kg x 100 g
Display resolution:
body fat: 0.1 %
Display resolution:
body water: 0.1 %
Display resolution:
muscle mass: 0.1 %
Display resolution:
bone masse 0.1 %
Personal memory locat.:
10 positions
Age:
10 – 80 years
Body height:
100 – 225 cm
Dimensions:
approx. 310 mm x 300 mm x 23 mm
Batteries:
2 x CR 2032 (included)
Subject to technical modifications
9. Warranty
ADE warrants for a period of 3 years from the date of purchase that it will remedy any
defects due to faulty material or workmanship free of charge by repair or replacement.
When purchasing, please have the warranty coupon signed and stamped by the dealer.
When making a guarantee claim, please return the weighing scale together with the
guarantee card including the reason of complaint to your dealer.
CE-Conformity - This device fea tures radio interference
supp ression in complian ce with valid EC Regulation 2004/108
Note: The displayed value may be adversely affected under extreme electromagnetic
influences, e.g. when using a radio unit in the immediate vicinity of the device. Once the
interference has been rectified, the product can once again be used for its intended
purpose. The device may have to be switched-on again.
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ba 832

Table des Matières