Magnavox 52MF437S Manuel De L'utilisateur page 9

_________________________
2.1.3 Connect to the TV
Your Magnavox Digital TV will allow you to enjoy digital programs
directly from your cable or off air.
Connect directly to the TV or connect via your current cable box or
Satellite Receiver box.
________________________
2.1.3.1 Directly to the TV (you will not be able to receive pay
channels)
ANTENNA
1. Connect the cable TV signal or the incoming antenna signal to the
: Ω
ANTENNA 75 jack at the bottom of the TV.
2. See Chapter 7.3 Store TV channels for details on using
Autoprogram to store channels in the TV's memory.
- Broadcasters are in the middle of a transition from analog to digital
TV. This means that a given broadcaster will have two channels on
the air, one analog and one digital.
- This connection will supply stereo sound to the TV if it is being
broadcast by the station you are watching.
VIDEO L AUDIO R
AV 2
AV2
L + R + VIDEO
OUT
Set top box
________________________
2.1.3.2 Via a cable box or Satellite box
1. Maintain the connection of the TV cable of your home into your
cable box (or satellite receiver box).
2. Connect your Cable box (or satellite receiver box) to the back of
the TV using the best connection options. See Chapter 10.2 To
make audio and video connections.
3. Select the source using the AV
4. Press the button to confirm your selection.
OK
For more information, please refer to your cable box (or satellite
receiver box) manual.
ANTENNA
CABLE
RF IN
button on the remote control.
Watching Cable TV programs that don't require the cable
box
Since you've connected the cable TV signal directly to the TV's tuner,
you can also watch the unscrambled programs by simply tuning to
the desired channel. You must first use Autoprogram, however, to
store channels in the TV's memory. See Chapter 7.3.
This connection will supply stereo sound to the TV if it is being
broadcast by the station you are watching.
_________________________
2.1.4 Connect the mains
MAINS
!
Verify that the power supply voltage corresponds to the voltage
printed on the sticker at the back of the TV. Contact your local
dealer if your power supply is different.
Ensure the power cord is fully inserted in the TV mains socket and
!
the wall socket.
_________________________
2.1.5 Remote control
Insert the 2 batteries supplied (Type R03-1,5V).
Be sure the (+) and (-) ends of the batteries line up correctly (inside of
case is marked.)
5 5