Operation; Open Top Burners; Ovens (Standard); Hot Top Sections - Garland SUNFIRE X Serie Instructions D'installation Et D'utilisation

OPERATION

Open Top burners

Lighting
1 . Light pilots adjacent to each burner .
2 . Turn valve completely on . Burner flame should be 1/2"
(13mm) high, stable and blue in color . It should also
impinge on the bottom of a pot placed on the burner
grate .
CAUTION: Should burner ignition fail within 4 seconds, turn
the burner valve off and repeat steps 1 through 2 . If ignition
continues to fail, consult your factory authorized service
agency .

Ovens (Standard)

Lighting
1 . Lower front kick panel below oven door, raise oven
hearth bottom for easy access to oven pilot .
2 . Turn oven control knob (figure 1) to "
then push in to engage the flow of gas through the safety
device to the pilot .
Figure 1
3 . While holding knob in, light pilot with a match/BBQ
lighter or use the spark ignition (if provided) to spark
ignite pilot .
4 . Continue to hold knob in for 15 seconds after ignition,
then release . Pilot should remain lit .
5 . If pilot burner fails to light or does not stay lit, wait 5
minutes and repeat steps 2 through 4 .
6 . Replace hearth and close kick panel, then turn oven
thermostat to desired cooking temperature .
Part # 4523343 Rev 1 (02/12/08)
7 . To shut down main burner turn control knob (figure 1) to
"
Shut Down
If pilot shut is down is required remove the temperature
thermostat knob by pulling it off carefully, then turn the
inner control knob (figure 2) to
disengage with 60 seconds .
Figure 2
" position and

Hot Top Sections

1 . Raise or remove hot top plate section(s) . Each burner has
one pilot located at the front left side of the burner .
2 . Light pilots . The pilot burner should be adjusted to
provide for rapid ignition of the burner .
3 . Turn the burner valve on . A sharp blue flame should be
approximately 1/4-inch, (6mm), high .
4 . Replace hot top sections .

Valve Controlled Griddles

See griddle seasoning before use .
1 . Pilots should be lit though the front panel with an extend
match . If necessary the front panel of the range can be
removed to allow the griddle plates to be raised at the
front, block securely .
2 . Light pilots located at the front right side of each burner .
3 . Turn burner valves completely on . Burners should have
1/2-inch to 5/8-inch, (13mm to 16mm), stable blue flame .
4 . If the griddle has been raised, lower carefully into position
and replace the front panel of the range .
" position .
position . The system will
Page 9