Télécharger Imprimer la page

Publicité

Liens rapides

INSTALLATION AND
OPERATION MANUAL
GARLAND® STARFIRE
SENTRY COMBINATION
RANGE, MODEL STW286A
FOR YOUR SAFETY:
DO NOT STORE OR USE GASOLINE
OR OTHER FLAMMABLE VAPORS OR
LIQUIDS IN THE VICINITY OF
THIS OR ANY OTHER
IMPROPER INSTALLATION, ADJUSTMENT,
ALTERATION, SERVICE OR MAINTENANCE
CAN CAUSE PROPERTY DAMAGE, INJURY,
OR DEATH. READ THE INSTALLATION,
OPERATING AND MAINTENANCE
INSTRUCTIONS THOROUGHLY
BEFORE INSTALLING OR
SERVICING THIS EQUIPMENT
Users are cautioned that maintenance and repairs must be performed by a Garland authorized service agent
using genuine Garland replacement parts. Garland will have no obligation with respect to any product that has been
improperly installed, adjusted, operated or not maintained in accordance with national and local codes or installation
instructions provided with the product, or any product that has its serial number defaced, obliterated or removed,
or which has been modified or repaired using unauthorized parts or by unauthorized service agents.
For a list of authorized service agents, please refer to the Garland web site at http://www.garland-group.com.
The information contained herein, (including design and parts specifications), may be superseded and is subject
to change without notice.
GARLAND COMMERCIAL RANGES, LTD.
1177 Kamato Road, Mississauga, Ontario L4W 1X4
CANADA
Phone: 905-624-0260
Fax: 905-624-5669
Part # 4517957 Rev 13 (02/10/11)
Part # 4517957 Rev.13 (02/10/11)
All manuals and user guides at all-guides.com
APPLIANCE
WARNING:
PLEASE READ ALL SECTIONS OF THIS MANUAL
AND RETAIN FOR FUTURE REFERENCE.
THIS PRODUCT HAS BEEN CERTIFIED AS
COMMERCIAL COOKING EQUIPMENT AND
MUST BE INSTALLED BY PROFESSIONAL
PERSONNEL AS SPECIFIED.
IN THE COMMONWEALTH OF MASSACHUSETTS
THIS PRODUCT MUST BE INSTALLED BY A
LICENSED PLUMBER OR GAS FITTER. APPROVAL
NUMBER: G-1-07-05-28
For Your Safety:
Post in a prominent location, instructions to be
followed in the event the user smells gas. This
information shall be obtained by consulting
your local gas supplier.
© 2010 The Garland Group.
Page 1

Publicité

loading

Sommaire des Matières pour Garland STW286A

  • Page 1 Users are cautioned that maintenance and repairs must be performed by a Garland authorized service agent using genuine Garland replacement parts. Garland will have no obligation with respect to any product that has been improperly installed, adjusted, operated or not maintained in accordance with national and local codes or installation instructions provided with the product, or any product that has its serial number defaced, obliterated or removed, or which has been modified or repaired using unauthorized parts or by unauthorized service agents.
  • Page 2 All manuals and user guides at all-guides.com IMPORTANT INFORMATION WARNING: This product contains chemicals known to the state of California to cause cancer and/or birth defects or other reproductive harm. Installation and servicing of this product could expose you to airborne particles of glass wool/ceramic fibers.
  • Page 3 WIRING DIAGRAMS . . . . . . . . . . . . . . . . . . 20 Solid Hot Tops (STW286A) ....11 For Models Manufactured Up To Lighting The Solid Hot Top .
  • Page 4 All manuals and user guides at all-guides.com DIMENSIONS 10' POWER CORD 3/4" NPT REAR AT REAR [120V] GAS INLET GUARD 10 1/2" 1 1/2" [267mm] [38mm] 3 3/4" [95mm] 3 1/2" [83mm] 39 1/2" 28" [1003mm] [711mm] 5" [127mm] 12" 24"...
  • Page 5 Garland/U.S. Range products are not approved or authorized for home or residential use, but are intended for commercial applications only. Garland / U.S. Range will not provide service, warranty, maintenance or support of any kind other than in commercial applications..
  • Page 6 “ON. ” A preset on the name/rating plate. Connect a unit stamped “NAT” gas pressure regulator is supplied with GARLAND only to natural gas, and a unit stamped “PRO” only to Restaurant Series Equipment. It may be necessary to propane.
  • Page 7 Proper ventilation is essential for optimum performance. MINIMUM CLEARANCES STW286A The ideal method of ventilating equipment is the use of a LOCATION CLEARANCE...
  • Page 8 All manuals and user guides at all-guides.com INSTALLATION continued TABLE A. Gas Flow Rate (total) NATURAL GAS ( ft /h ) PROPANE GAS (ft /h ) TABLE B. Heat Input Per Burner NOMINAL HEAT INPUT BURNER NATURAL GAS PROPANE BTU/HR MJ/HR BTU/HR MJ/HR...
  • Page 9 All manuals and user guides at all-guides.com INSTALLATION continued Commissioning: 3. With a flat screwdriver, turn the adjuster on the body of the tap clockwise to reduce the pressure or anti-clockwise The whole of the gas installation, including the meter, should to increase pressure.
  • Page 10 Operation Controls SOLID TOP (STW286A) Griddles Griddle tops are designed to have food cooked directly on the surface. Do not put pots or pans on the griddle surface as this will scratch or nick the surface and will result in improper cooking or sticking of the product.
  • Page 11 “O” position. the oven on from cold, with the thermostat at the desired temperature before loading the oven with food to be Solid Hot Tops (STW286A) cooked. Put the food in quickly and close the oven door. Convection Oven Recommended where long term stock pot cooking is required for soups, sauces or stocks.
  • Page 12 All manuals and user guides at all-guides.com OPERATION continued Operating Suggestions 3. If ignition fails and or the ignition system goes into lockout, set the power switch to the “O” position. 1. Turn the power switch to the “O” position when the range 4.
  • Page 13 All manuals and user guides at all-guides.com MAINTENANCE & CLEANING continued Griddle Griddle Do’s & Don’ts Cleaning instructions (After each use) Do’s 1. Use a traditional 2.5”-3” (64mm-76mm) scraper or spatula 1. Season the griddle, This will prevent foods from sticking to scrape the griddle surface (to remove food particles and make it easier to keep the surface clean.
  • Page 14 All manuals and user guides at all-guides.com MAINTENANCE & CLEANING continued Convection Oven 1. Place the thermocouple of the test instrument in the center of the oven. 1. Open the lower kick panel. 2. Turn the oven temperature control dial to 400°F. In order 2.
  • Page 15 All manuals and user guides at all-guides.com MAINTENANCE & CLEANING continued 5. Hold the thermostat shaft steady and with a small flat TOP VIEW blade screw driver, turn the calibration screw located 12.0 24.0 inside the shaft clockwise to decrease the temperature and anti-clockwise to increase the temperature.
  • Page 16 Injector fittings ( One required for each main burner & one required for each pilot). b. Regulator, (one per unit ). If any of the required parts are missing, contact your Garland dealer before attempting to carry out the conversion. Page 16 Part # 4517957 Rev. 13 (02/10/11)
  • Page 17 All manuals and user guides at all-guides.com FAULT FINDING PROBLEM POSSIBLE CAUSES SOLUTION No power to oven. Check power supply. Defective Cook/Cool Down switch Replace switch. Cook/Cool Down switch set to “Cook” Check condition of all wires & Faulty wiring. position.
  • Page 18 All manuals and user guides at all-guides.com REPLACEMENT OF PARTS WARNING: Turn off the gas supply to the appliance at the 3. Disconnect the wires from the taps on the switch. Be sure service cock and the electrical mains before commencing to note which wire connects to which terminal on the any servicing work.
  • Page 19 All manuals and user guides at all-guides.com REPLACEMENT OF PARTS continued Ignition Control 6. Replace the control and reassemble in the reverse order. Front Cooling Fan 1. Remove the fastener securing the control compartment access panel. 1. Remove fastener securing the control compartment 2.
  • Page 20 All manuals and user guides at all-guides.com WIRING DIAGRAMS Page 20 Part # 4517957 Rev. 13 (02/10/11)
  • Page 21 All manuals and user guides at all-guides.com WIRING DIAGRAMS continued Part # 4517957 Rev.13 (02/10/11) Page 21...
  • Page 22 All manuals and user guides at all-guides.com WIRING DIAGRAMS continued Page 22 Part # 4517957 Rev. 13 (02/10/11)
  • Page 23 All manuals and user guides at all-guides.com WIRING DIAGRAMS continued Part # 4517957 Rev.13 (02/10/11) Page 23...
  • Page 24 All manuals and user guides at all-guides.com WIRING DIAGRAMS continued Page 24 Part # 4517957 Rev. 13 (02/10/11)
  • Page 25 All manuals and user guides at all-guides.com WIRING DIAGRAMS continued Part # 4517957 Rev.13 (02/10/11) Page 25...
  • Page 26 All manuals and user guides at all-guides.com Revision History Page Description Date Part list removed - was on page 20 to 27. Oct 27/10 Removed Garland Commercial Industries, front Cover Page 26 Part # 4517957 Rev. 13 (02/10/11)
  • Page 27 All manuals and user guides at all-guides.com Part # 4517957 Rev.13 (02/10/11) Page 27...
  • Page 28 All manuals and user guides at all-guides.com...
  • Page 29 All manuals and user guides at all-guides.com...
  • Page 30 All manuals and user guides at all-guides.com...
  • Page 31 All manuals and user guides at all-guides.com...
  • Page 32 All manuals and user guides at all-guides.com...
  • Page 33 All manuals and user guides at all-guides.com...
  • Page 34 All manuals and user guides at all-guides.com G 770 GROUND GROUND THS 2 THS 2 P.V. 1 P.V. 1 M.V. 3 M.V. 3 SENSE 4 SENSE 4...
  • Page 35 All manuals and user guides at all-guides.com G 770 GROUND GROUND THS 2 THS 2 P.V. 1 P.V. 1 M.V. 3 M.V. 3 SENSE 4 SENSE 4...
  • Page 36 All manuals and user guides at all-guides.com SP 845 SPARK...
  • Page 37 All manuals and user guides at all-guides.com SP 845 SPARK...
  • Page 38 All manuals and user guides at all-guides.com...
  • Page 39 All manuals and user guides at all-guides.com...
  • Page 40 All manuals and user guides at all-guides.com...
  • Page 41 All manuals and user guides at all-guides.com...
  • Page 42 All manuals and user guides at all-guides.com...
  • Page 43 All manuals and user guides at all-guides.com...
  • Page 44 All manuals and user guides at all-guides.com...
  • Page 45 All manuals and user guides at all-guides.com...
  • Page 46 All manuals and user guides at all-guides.com...
  • Page 47 All manuals and user guides at all-guides.com...
  • Page 48 All manuals and user guides at all-guides.com...
  • Page 49 All manuals and user guides at all-guides.com...
  • Page 50 All manuals and user guides at all-guides.com...
  • Page 51 All manuals and user guides at all-guides.com...
  • Page 52 All manuals and user guides at all-guides.com...
  • Page 53 All manuals and user guides at all-guides.com...
  • Page 54 All manuals and user guides at all-guides.com...
  • Page 55 All manuals and user guides at all-guides.com...
  • Page 56 All manuals and user guides at all-guides.com...