Publicité
Les langues disponibles
Les langues disponibles
metal centrifugal juicer
Use the centrifugal juicer for making juice from firm fruit
and vegetables.
pusher
centrifugal lid
pulp remover
filter drum
juicer drive shaft
to use the centrifugal juicer
1 Fit the juicer drive shaft and bowl onto the power unit.
2 Place the pulp remover
the tabs locate with the slots in the bottom of the drum
3 Fit the filter drum
.
4 Place the attachment lid
locks
. Your juicer will not operate if the bowl or
lid are not fitted correctly into the interlock
5 Place a suitable glass or jug under the juice outlet.
6 Cut the food to fit the feed tube.
7 Switch on and push down evenly with the pusher - never
put your fingers in the feed tube. Process fully before
adding more.
After adding the last piece, let the juicer run for a further 30
G
seconds to extract all the juice from the filter drum.
safety
Do not use the juicer if the filter is damaged.
G
The cutting blades on the base of the filter drum are very
G
sharp, take care when handling and cleaning the drum.
Only use the pusher supplied. Never put your fingers in the
G
feed tube. Unplug before unblocking the feed tube.
Before removing the lid, switch off and wait for the filter to
G
stop.
important
I
f the juicer starts to vibrate, switch off and empty the pulp
G
from the drum. (The juicer vibrates if the pulp becomes
unevenly distributed).
Maximum capacity that can be processed at one time is
G
500g of fruit or vegetables.
Some very hard foods may make your juicer slow down or
G
stop. If this happens switch off and unblock the filter.
Switch off and clear the pulp collector regularly during use.
G
hints
Before processing remove stones and pips (eg pepper,
G
melon, plum) and tough skins (eg melon, pineapple). You
don't need to peel or core apples and pears.
Use firm, fresh fruit and vegetables.
G
Citrus fruit - peel and remove the white pith, otherwise the
G
juice may taste bitter. For best results use the citrus juicer.
into the filter drum
- ensuring
onto the bowl and turn until it
KENSTORE™ attachments carousel
Your food processor is supplied with an attachment storage
carousel that fits inside the bowl.
to use the storage carousel
1 Fit the knife blade to the bowl.
2 Then fit the whisk, discs and canopy into the carousel
3 Fit the carousel over the knife blade and place the processor
lid on top
care & cleaning
Always switch off and unplug before cleaning.
G
.
Handle the blades and cutting discs with care -
G
they are extremely sharp.
Some foods may discolour the plastic. This is perfectly
G
normal and won't harm the plastic or affect the flavour of
.
your food. Rub with a cloth dipped in vegetable oil to remove
the discolouration.
power unit
G
Wipe with a damp cloth, then dry. Ensure that the interlock
area is clear of food debris.
G
Store excess cord in the storage area at the back of the
power unit
liquidiser/mini chopper/mill
1 Empty the goblet/jar before unscrewing it from the blade
unit.
2 Wash the goblet/jar by hand.
3 Remove and wash the seals.
4 Don't touch the sharp blades – brush them clean using hot
soapy water, then rinse thoroughly under the tap. Don't
immerse the blade unit in water.
5 Leave to dry upside down.
twin beater geared whisk
Detach the beaters from the drive head by gently pulling
G
them free. Wash in warm soapy water.
Wipe the drive head with a damp cloth, then dry.
G
Do not immerse the drive head in water.
centrifugal filter drum
Lift out the pulp remover and tap lightly to release the pulp.
G
Clean using a soft brush.
G
Check the filter regularly for signs of damage. Do
G
not use if the filter is damaged. Refer to "service
and customer care".
6
.
.
.
Publicité
