Kenwood kMix FPX930 Serie Instructions page 11

troubleshooting guide
Problem
The processor will not operate
Liquidiser/mini chopper/mill
will not operate
Processor stops during
processing
Liquidiser/mill leaking from
blade assembly base.
Poor performance of
tools/attachments.
Cause
No power/indicator light not lit.
Bowl not fitted to power unit correctly.
Bowl lid not locked on correctly.
Liquidiser/mini chopper/mill not locked
on correctly.
Liquidiser/mini chopper/mill not
assembled correctly.
Processor overloaded/maximum capacities
exceeded.
Lid unlocked.
Seal missing
Seal incorrectly fitted
Seal damaged.
Refer to hints in relevant "using the attachment" section. Check attachments are
assembled correctly.
Solution
Check processor is plugged in
Check bowl is located correctly and the
handle is situated towards the right hand side.
Check that the lid interlock is located correctly
into the handle area.
The processor will not work if the
bowl and lid are fitted incorrectly.
If none of the above check the fuse/circuit
breaker in your home.
The liquidiser/mini chopper/mill will not
operate if fitted incorrectly to the interlock.
Check blade unit is fully tightened into
the goblet.
Check maximum capacities stated in the
recommended speed chart.
Check lid is locked correctly.
Check seal is fitted correctly and not
damaged. To obtain a replacement
seal see "service & customer care"
8