Black & Decker FS1610R Mode D'emploi page 5

Warning! If your product is class ll double
insulated (only 2 wires in the cord set), no
connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs
Any replacement fuse must be of the same
rating as the original fuse supplied with the
product.
Assembly
Make sure your fan is switched off before
connecting to or disconnecting from power
supply. Ensure that the voltage rating on the
base plate corresponds to the main voltage at
your home.
Remove all packaging from the parts of the fan.
Warning! Never use the fan without the guard in
place or if the guard is damaged.
Assembling the base and stand
•
Remove the screw from the support tube by
turning it anti-clockwise.
•
Place the support tube into the base.
Re-insert the screw into the support tube
from underneath. Tighten the screw by
turning it clockwise.
Fitting the fan to the stand
•
Remove the screw from the bottom of the fan
unit by turning it anti-clockwise.
•
Place the fan unit onto the top of the support
tube. Re-insert the screw into the fan unit.
Tighten the screw by turning it clockwise.
Fitting the fan blade and guard
•
Remove the blade cap from
the motor shaft by turning it
clockwise.
•
Remove the guard nut from the
motor shaft by turning it
anti-clockwise.
•
Place the rear guard by positioning it on the
location pins on the fan head. (ensure that
the rear guard is in the correct orientation)
•
Secure the guard on to the fan head by
re-fitting the guard nut. Tighten the guard nut
by turning it clockwise.
•
Place the fan blade onto the motor shaft.
ENGLISH
5