Saber R33SC0012 Guide Des Produits page 3

Installation Safety Precautions
Use grill, as purchased, only with LP (propane) gas and
the regulator/valve assembly supplied. A conversion kit
must be purchased for use with natural gas.
Grill installation must conform with local codes, or in their
absence of local codes, with either the National Fuel Gas
Code, ANSI Z223.1/ NFPA 54, Natural Gas and Propane
Installation Code, CSA B149.1, or Propane Storage and
Handling Code, B149.2, or the Standard for Recreational
Vehicles, ANSI A 119.2/NFPA 1192, and CSA Z240 RV
Series, Recreational Vehicle Code, as applicable.
All electrical accessories (such as rotisserie) must be
electrically grounded in accordance with local codes, or
National Electrical Code, ANSI / NFPA 70 or Canadian
Electrical Code, CSA C22.1. Keep any electrical cords
and/or fuel supply hoses away from any hot surfaces.
This grill is safety certified for use in the United States
and/or Canada only. Do not modify for use in any other
location. Modification will result in a safety hazard.
The pressure regulator and hose assembly supplied must
be used and replacements must be those specified by
appliance manufacturer.
WARNING
Do not attempt to repair or alter the
hose/valve/regulator for any "assumed" defect. Any
modification to this assembly will void your warranty
and create the risk of a gas leak and fire. Use only
authorized replacement parts supplied by
manufacturer.
USE AND CARE
LP Cylinder Removal, Transport and Storage
Turn OFF all control knobs and LP cylinder valve. Turn
coupling nut counterclockwise by hand only - do not use tools
to disconnect. Loosen cylinder screw beneath bottom shelf,
then lift LP cylinder up and out of cart. Install safety cap onto
LP cylinder valve. Always use cap and strap supplied with
valve. Failure to use safety cap as directed may result in
serious personal injury and/or property damage.
LP Cylinder Removal, Transport and Storage Con't.
A disconnected LP cylinder in
storage or being
transported must have a safety cap
installed (as shown). Do not store an LP
cylinder in enclosed spaces such as a
carport, garage, porch, covered patio or
other building. Never leave an LP cylinder
inside a vehicle which may become overheated
by the sun.
Do not store an LP cylinder in an area where children play.
LP Cylinder Valve
Safety
Cap
Retainer Strap
LP Cylinder
The LP cylinder used with your grill must meet the following
requirements:
Use LP cylinders only with these required measurements: 12"
(30.5cm) (diameter) x 18" (45.7cm) (tall) with 20 lb. (9kg) capacity
maximum.
LP cylinders must be constructed and marked in accordance with
specifications for LP cylinders of the U. S. Department of
Transportation (DOT) or for Canada, CAN/CSA-B339, cylinders,
spheres and tubes for transportation of dangerous goods.
Transport Canada (TC). See cylinder collar for marking.
LP cylinder valve must have:
-Type 1 outlet compatible with
regulator or grill.
-Safety relief valve.
-UL listed Overfill Protection
Device (OPD). This OPD safety
feature is identified by a unique triangular hand wheel. Use only
LP cylinders equipped with this type of valve.
LP cylinder must be arranged for vapor withdrawal and include
collar to protect LP cylinder valve. Always keep LP cylinder in
upright position during use, transit or storage.
LP cylinder in upright position for vapor withdrawal
LP (Liquefied Petroleum Gas)
LP gas is nontoxic, odorless and colorless when produced. For
Your Safety, LP gas has been given an odor (similar to rotten
cabbage) so that it can be smelled.
LP gas is highly flammable and may ignite unexpectedly when
mixed with air.
LP Cylinder Filling
Use only licensed and experienced dealers.
LP dealer must purge new cylinder before filling.
Dealer should NEVER fill LP cylinder more than 80% of LP
cylinder volume. Volume of propane in cylinder will vary by
temperature.
A frosty regulator indicates gas overfill. Immediately close LP
cylinder valve and call local LP gas dealer for assistance.
Do not release liquid propane (LP) gas into the atmosphere.
This is a hazardous practice.
To remove gas from LP cylinder, contact an LP dealer or call a
local fire department for assistance. Check the telephone
directory under "Gas Companies" for nearest certified LP
dealers.
OPD Hand Wheel
3