Alliance Laundry Systems FR-A800 Serie Instructions page 5

www.groupdynamics-laundry.com
sales@groupdynamics.lv
Item
PID control
Automatic restart after instantaneous
power failure
Number of motor poles V/F control
switch
PTC thermistor input
USB connector
Control circuit terminal block
Terminal response level
PU
Plug-in option
Communication option
Installation size
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
FR-A700
Turn the X14 signal ON to enable PID
control.
Turn the CS signal ON to restart.
The V/F switch signal (X18) is valid when
Pr.81 = "12 to 20 (2 to 10 poles)".
Input from the terminal AU (The function
of the terminal AU is controlled by a
switch.)
B connector
Removable terminal block (screw type)
The FR-A800's I/O terminals have better response level than the FR-A700's terminals.
By setting Pr.289 Inverter output terminal filter and Pr.699 Input terminal filter, the ter-
minal response level will be compatible with FR-A700. Set to approximately 5 to 8 ms
and adjust the setting according to the system.
FR-DU07 (4-digit LED)
FR-PU07
Dedicated plug-in options (not interchangeable)
Connected to connector 3
For standard models, installation size is compatible for all capacities. (Replacement
between the same capacities does not require new mounting holes.)
For separated converter types, installation size is not compatible. (New mounting
holes are required.)
5
FR-A800
The X14 signal does not need to be as-
signed. (PID control is available by the
Pr.128 setting.)
The PID pre-charge function and jog
control are added.
CS signal assignment not required. (Re-
start is enabled with the Pr.57 setting only.)
Pr.81 = "12 (12 poles)"
Input from terminal 2. (The function of
terminal 2 is controlled by the Pr.561 set-
ting.)
Mini B connector
Removable terminal block (spring clamp
type)
FR-DU08 (5-digit LED)
FR-PU07 (Some functions, such as pa-
rameter copy, are unavailable.)
FR-DU07 is not supported.
Connected to connector 1
Form No. 12-15-425ENR1