Proper Use; Technical Data - Abicor Binzel MB 14 Mode D'emploi

2. Proper use

3. Technical data

The WIG / MAG welding torches of this series are exclusively intended for shiel-
ded arc welding using inert gases (MIG) or active gases (MAG) for industrial and
commercial use by specially trained employees. They are available as manual
and machine-operated versions.
The welding torches of the MIG / MAG series can be used in any welding position.
A coolant unit is required for liquid-cooled welding torches
The operating unit in the handle ERGO is suitable for max. 42 V and 0.1 Amps
up to 1.0 Amps.
The welding torch should only be operated using original ABICOR BINZEL
spare parts.
The operator must ensure that the welding torch and welding device
comply with the EC Directive EMC (89/336/EEC).
The welding torch is exclusively intended for the application described above.
Any use beyond that is prohibited.
Proper use also requires adherence to the operation, servicing and maintenan-
ce conditions as set by the manufacturer.
The warranty does not cover consumables or damage due to overloading or
improper handling.
Unauthorized conversions and modifications are prohibited for reasons of
safety and liability.
The tasks described in these operating instructions are explained in a way,
which can only be performed by qualified personnel.
According to the definitions found in EN-60204-1:
Qualified personnel are persons who, based on their special training, knowledge,
experience and due to their knowledge of the relevant standards, are able to
assess the tasks assigned to them and identify possible dangers.
General data
Ambient Temperature
– when welding:
– during shipment and storage:
Relative air humidity:
– 10 °C to + 40 °C
– 25 °C to + 55 °C
up to 90 % at a temperature of 20 °C
®