Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Problems
The lights will not turn on
There is no power on one side of
your LS8
(A and B zones on the left side, C
and D zones on the right side)
TROUBLESHOOTING
Actions
Verify that there is power to the
120V trigger input. You will hear a
loud "click" caused by relay
switching when power is applied
to the trigger input.
Check if the main circuit breaker
and the LS8 breakers are in the
ON position, and reset them if
necessary.
Verify that the unit is wired
properly
Check with a licensed electrician if
there are any concerns regarding
proper installation of your LS8
Check if the corresponding LS8
breakers have tripped. The
breaker actuator must be firmly
engaged in the ON position (UP).
Check if the wire jumpers
between JP1 and JP4 (trigger
input connectors) are properly
connected and tightened.
7
Publicité
Table des Matières
