Installation Guide - Grozone Control LS8 Guide De L'usager

IMPORTANT: THIS PRODUCT MUST BE INSTALLED BY A
1. Unscrew the 4 screws from the cover.
2. Secure the LS8 to the wall using the included hardware (#8 wood
screws in keyhole shaped mounting holes)
3. Use the correct size wire for your application. Please check local
electrical codes for wire sizing requirements. Carefully strip the 2
power wires approximately 1''. Pass the stripped and copper wires
through the biggest strain relief at the bottom of the LS8.
Connect 240V wires as follows:
 Black wire to the JP5 connector L1
 Red wire to the JP5 connector L2
 Copper wire to the GROUND LOG
located on the bottom wall of the
enclosure, close to the metallic wire
connectors.
4. Tighten all of your connections and strain relief.
4

INSTALLATION GUIDE

LICENSED ELECTRICIAN ONLY