Grozone Control LS8 Guide De L'usager page 15

OPTIONAL: USE OF 2 TRIGGER INPUTS
1. Remove panel knockout located at the bottom right of the LS8.
Please don't do it with your bare hands and use proper tooling.
2. Remove wire jumpers from JP1 and JP4
connectors.
3. Pass the 120V trigger wire through the smallest strain relief and
connect the conductors as follows:
 Black wire to the JP1 connector L1
 White wire to the JP1 connector
NEUTRE (Neutral)
 Green wire to the JP1 connector GND
4. Tighten all of your connections and strain relief.
5. Screw back on the LS8 cover with included hardware. Do not over
tighten to avoid stripping screw threads.
6
INSTALLATION GUIDE