Dräger Secor 7000 Notice D'utilisation page 42

en Maintenance
Mounting the exhalation valve:
Attach exhalation valve if necessary.

Installing the diaphragm:
1. Moisten diaphragm rim (4) with water. Insert diaphragm in
lower rim, diaphragm should lie flat all round, the bump with
the contact plate should face upwards.
2. Moisten support ring (3) with water and insert.
Installing the bubble deflector and front cap:
1. Hook the bubble deflector into the bottom of the device and
press onto the housing.
2. Pull the front cap over the housing from the top down and
hook the mounting bracket onto the bubble deflector.
NOTICE
Ensure correct seating of the front cap on the housing. The
front cap must snap into the surrounding groove!
42
1
4
3
5
2
6
00331318