Groeneveld ECOPLUS Mode D'emploi page 7

The signal lamp
The signal lamp is mounted in the field of vision of the driver
and out of direct sunlight, because of the visibility of signals.
When the control unit detects an error the signal lamp will
be lit continuously. (root cause of the error can be read out
on the display).
The signal lamp resets automaticly when a correct cycle
has been performed with out errors.
The signal lamp blinks at low level (when low level switch is installed)
Problem
Signal lamp does 1. No suppy voltage (+15) on
not light up after pin Nº 1 or at signal lamp
ignition is switched
on 2. No ground potential on pin
Nº 2
3. Signal lamp defect
4. Wiring to the pump unit or
signal lamp defect
Signal lamp flashes Low grease level in the car-
tridge
Signal lamp An system error occured or
alsways on cartridge is empty
Faults codes by user interface
When an error or warning occurs this will be shown on the status screen of the
user interface.
Message
Low level Grease in the cartridge reached
the level where it activates the low
level switch. replaceing the car-
tridge will soon be necessary.
Empty Pump disabled and theoretical-
ly declared empty because the
maximum allowed grease quantity
during active low level has finished
Low volt Power drop detected by the control
unit.
Timing The total amount of revolution of
the motor to complete a greasing
cycle takes longer then the set
interval time causing overlap
F604055R00
Cause
Cause
Replace the cartridge. Lamp
resets automaticly when cartridge
is replaced.
Replace the cartridge. Lamp
resets automaticly when cartridge
is replaced.
Check that power connection.
Use a relay if needed.
Check the interval and delivery
settings currently made in the
pump.
Solution
Check the fuse and, if re-
quired replace fuse.
Check the ground connection
and repair if needed
Replace the signal lamp
Check the wiring and repair if
needed
Replace the cartridge.
order number F130827
Use the user interface to de-
termine the root cause.
Solution
EN