Klarstein EL PASO Mode D'emploi page 12

EN
12
OPERATION
Manual
• Select the fan speed by pressing the speed control button on the remote control
transmitter:
HI: High Speed
MED: Medium Speed
LOW: Low Speed
OFF: Off
• The switch on motor housing for controlling the fan blades rotating direction controls
the direction of air movement. Before using this rotating direction switch, turn OFF
the fan and ensure the fan stops rotating to prevent injury to yourself and damage
to the motor.
• Cold weather: Push the switch "UP" so that the blades will bring the warm air
trapped near the ceiling fan to move downwards throughout the room.
• Hot weather: Push switch "DOWN" so that the blades will create a breeze and
circulate the air to the room.
Remote Control
• Pressing the "ON/OFF" light button on the remote control transmitter can control
the turning on or off of the light.
• Pressing and holding the "DIMMER" button on the remote controller transmitter can
adjust the level of light brightness.
• Use the remote control transmitter to change the speed of the fan and to switch the
light and fan on or off.
• Replace the batteries by sliding the battery compartment cover on the remote
control transmitter in the direction of the arrow, fit 2 x "AAA" batteries, ensure the
polarity of the batteries match with the figures shown in the battery compartment
Note: The batteries for the remote control are NOT included.
• Always ensure the battery compartment cover is closed properly.
• Do not expose the remote control to direct sunlight.
• Do not attempt to recharge expired batteries. There are special rechargeable
batteries, which are clearly marked with.
• Do not dispose of batteries in fire to avoid explosion.