Blumfeldt 10032516 Mode D'emploi page 13

Electric Safety
• The unit must be placed with the clearance of 180 cm to the floor and 30
cm to the ceiling.
• When the power supply cord is damaged, it must be replaced by
authorized agent or other professional people to avoid danger. The heater
must be securely grounded when in use.
• The heater should be plugged in a socket, which is easily visible and
reachable.
• If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• Wickeln Sie das Netzstromkabel nicht um den Heizstrahler.
• If the heater gets damaged, it must be repaired by professional
electricians.
• Do not use this heater with a programmer, timer, separate remote-control
system or any other device that switches the heater on automatically,
since a fire risk exist if the heater is covered or positioned incorrectly.
Mounting
• Mount the heater outside or in a large open area and well away from any
obstructions such as branches or where the heater is near any objects that
can be affected by heat, such as furniture, curtains or other inflammable
objects (minimum distance 1 meter).
• Place the heater on a firm, level ceiling surface.
• If the heaters are placed in areas where spray painting of any description
is taking place, they should not be used during the painting operations.
Never use the heater in particularly dusty and explosive areas.
• Do not position immediately above or below an electrical socket.
• The unit must be placed with the clearance of 180 cm to the floor and
50 cm to the ceiling.
• When assembling, keep away from any board or flammable material.
EN
13