Table des Matières
Publicité
Manuel de sécurité, de fonctionnement et de mainenance - Spider ILD01G
For Control Units S/N 96 001 xxxxx there is a possibility of neutral position adjustment by so called
Teach mode allowing trimming of neutral position on Remote controller
Set all proportional channels to zero position.
1) Activate the
Release the
programming
present.
mode
Press and hold the
seconds.
As a confirmation the horn will be activated briefly (2 times).
Do NOT press the
2) Adjust the
Standard value is 0.
Zero Position
Use steering joystick 9 for adjusting the value (left/right).
value
Each time you push the steering joystick to the left, the value will decrease by
one.
Pushing the steering joystick to the right will increase the value by one.
Each time you move the joystick to left or right, the horn will acknowledge the
movement.
) Save the value
For saving the value after changing, you have to push the
3
(12)
The values are stored now
Press the
4) Check the
EMERGENCY STOP
values
pressing the
If you are not content and want to change the values again, start over at point
1.
Restore the
Set all proportional channels to zero position. Release the
factory settings
STOP
/ default value
Press and hold the buttons
button" (13)
The factory settings / default values are restored automatically.
As a confirmation the horn will be activated briefly (4 times).
Release the switches. Press the
seconds. Release the
control to operate by pressing the
EMERGENCY STOP
"Motor Start" (4)
"HORN/ENABLE" (12)
button.
.
EMERGENCY STOP
switch again and prepare the control to operate by
"HORN/ENABLE" (12)
switch. Wait till the radio connection is present.
"Motor Start" (2)
for 5 seconds.
EMERGENCY STOP
40 / 55
switch and wait till the radio connection is
"Motor Stop" (3)
and
button!
switch. Wait 2-3 seconds. Release the
button.
"Frequency check/change
and
EMERGENCY STOP
switch
switch again and prepare the
"HORN/ENABLE" (12)
buttons for 5
"HORN/ENABLE"
EMERGENCY
.
Wait 2
button.
rev. 01-22-08-2016
Publicité
Table des Matières
