Replacing One Type Of Exhaust Filter With Another; Replacing The Thread Lifters; Cleaning The Roller On The Allteq Floorhead - Miele Compact C2 SD Série Mode D'emploi

 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter, making
sure it goes in properly, then press it
down into position.
 If you are using exhaust filter c, d or
e, you must also activate the
timestrip® filter change indicator (dia.
09).
After approx. 10–15 seconds, a thin red
line will appear in the left-hand side of
the display (dia. 10).
If you wish to fit an AirClean filter,
see the "Replacing one type of ex-
haust filter with another" section.
 Close the dust compartment lid.
Replacing one type of exhaust filter
with another (dia. 06)
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:
a AirClean
b AirClean Plus 50 (light blue)
c Silence AirClean 50 (grey)
d Active AirClean 50 (black)
e HEPA AirClean 50 (white)
Do not use more than one exhaust fil-
ter at a time.
When changing the filter, please note
1. If you wish to replace exhaust filter a
with filter b, c, d or e it is essential
that you remove the filter grille before
you fit the new exhaust filter.
If you are using exhaust filter c, d or
e, you must also activate the
timestrip® filter change indicator
(dia. 09).
2. If you wish to replace exhaust filter b,
c, d or e with filter a it is essential
that you also fit the filter grille* (dia.
33).
* Filter grille – see "Optional ac-
cessories"

Replacing the thread lifters

(dia. 36 + 37)
(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Replace
the thread lifters if the pile has worn
down.
 Lever the thread lifters from the slots.
To do so use a suitable tool, e.g. a flat
blade screwdriver.
 Fit new thread lifters.
Cleaning the roller on the AllTeQ
floorhead (dia. 38)
Clean the roller on the floorhead if re-
quired.
 Release the bearing (with bayonet fit-
ting) using a coin.
 Press the bearing out, and remove.
 Remove the roller.
 Remove any threads and hair, replace
the roller and refit the bearing, locking
it back into position.
Replacement parts are available from
your Miele dealer or from the Miele
Spare Parts Dept.
en
45