Send Measurements To A Welch Allyn Device - Welch Allyn 5002 Mode D'emploi

Directions for use
1. Connect the USB Type B male side of the cable to the USB port on the side of the
mast.
2. Connect the USB Type A male side of the cable into a USB port on your computer.
Windows automatically installs the necessary driver.
3. Start the customer-supplied data collection software configured to receive data on
the COM port assigned by Windows.
4. Press SEND DATA on the scale to send the current measurement to the computer.

Send measurements to a Welch Allyn device

The scale can connect to a Welch Allyn Connex
Connex
1. Connect the USB Type B male side of the cable to the USB port on the side of the
mast.
2. Connect the USB Type A male side of the cable into a USB port on the rear of your
device.
3. Press SEND DATA on the scale to send the current measurement to the device.
CAUTION Any computer connected to the scale must be running on
battery power, a 60601-1-compliant power supply, or a 60601-1-compliant
isolation transformer.
®
Spot Monitor.
CAUTION Any device connected to the scale must be running on battery
power, a 60601-1-compliant power supply, or a 60601-1-compliant isolation
transformer.
®
Vital Signs Monitor or a Welch Allyn
Scale operation 15