Model 5122 Stand-On Scale; Model 6002 Wheelchair Scale - Welch Allyn 5002 Mode D'emploi

10 Assembly and setup
Height gauge assembly (purchasable option)
If your scale was ordered with a height gauge, follow the installation instructions
included with the height gauge.

Model 5122 stand-on scale

The 5122 model scale is shipped assembled, so no assembly is required. It operates the
same as the 5002 model. Handrails are not available for this scale.

Model 6002 wheelchair scale

1. Carefully remove all parts from the shipping carton and inspect the components for
shipping damage.
2. Place the scale base on the floor or on a workbench.
3. Remove the bolts and washers from the rear of the scale base.
4. Insert the mast into the base. Ensure that the readout display is facing the patient
when the patient stands on the scale.
5. Fasten the mast with the bolts and washers removed in Step 3.
6. Tighten the bolts securely to ensure a solid connection is made.
Weighing deck mounting
1. Position the weighing deck so that the two sets of holes under the flaps are closest
to the mast.
2. Line the weighing deck up with the mounting holes in the aluminum plate.
3. Install the four flat head screws through the weighing deck.
4. Securely tighten the supplied mounting screws with the provided hex key.
Handrail mounting (purchasable option)
If your scale was purchased with an optional handrail, follow the installation instructions
included with the handrail.
Height gauge assembly (purchasable option)
If your scale was ordered with a height gauge, follow the installation instructions
included with the height gauge.
Welch Allyn Masted Scales