Weighing Procedure; Wheelchair Weighing Procedure (Model 6002) - Welch Allyn 5002 Mode D'emploi

12 Scale operation
One beep
Two beeps
Three beeps
No print, four
short beeps
No print, four
long beeps
Four long
beeps
Continuous
long beep

Weighing procedure

Make sure to select a consistent time of day to obtain a weight measurement.
Position the scale in a convenient and stable location.
1. Press ON to turn on the scale.
The scale sounds one beep.
2. Wait for the scale to display 0.0.
The scale sounds two beeps.
3. Place the patient on the scale and make sure that his or her weight is evenly
distributed.
The scale sounds three beeps and the patient's weight is displayed.
4. If necessary, press REWEIGH to perform another weight measurement.
5. If necessary, press RECALL to display the previously stored scale measurement.
The PRIOR WEIGHT LED flashes.
Note
A series of moving dashes indicates that a tared weight is stored in the scale memory, or
that there is a negative weight on the scale. Press ZERO to clear the tare value and reset
the scale.
If O-LOAd is displayed, the capacity of the scale has been exceeded.

Wheelchair weighing procedure (model 6002)

1. Make sure that the scale ramps are down.
2. Press the power button to turn on the scale.
The scale sounds one beep.
3. Wait for the scale to display 0.0.
The scale sounds two beeps.
Acknowledgment of a button press.
The scale is zeroed and ready to take a measurement.
The weight reading is obtained and displayed.
A print was requested, but valid weight is not displayed on the scale, or
the printer is in use.
There is a problem with the printer. Contact your service department.
The battery is too weak to operate the scale.
The scale has entered setup mode.
There is a problem with the scale. See the troubleshooting section.
A measurement is stored in the scale until a new weight is
taken and zeroes out.
Welch Allyn Masted Scales
PRINT
was pressed while