Axis T93F Serie Mode D'emploi page 13

Connectors and Buttons
For specifications and operating conditions, see page 13.
Network Connector (AXIS T93F20)
RJ45 Ethernet connector. Supports Power over Ethernet (PoE).
• PoE IN – Supplies the housing with power and Ethernet. Connect to network through
a PoE-enabled network switch.
• PoE OUT – Supplies the camera with power and Ethernet. Connect between the housing
and the camera.
NO TICE TICE
NO NO TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's instructions. For information
about regulatory requirements, see Regulatory Information on page 2.
Heater Connector (AXIS T93F10, AXIS T93F20)
4-pin terminal block used to power the holder's built-in heater and temperature sensor.
Power Connectors (AXIS T93F10)
Terminal connectors for AC/DC power.
• POWER IN — Supplies housing with power. Connect to external AC/DC power supply. The
connector is polarity independent.
• POWER OUT — Supplies camera with power. Connect between the housing and the
camera.
Specifications
Operating Conditions
The Axis product is intended for indoor and outdoor use.
Classification
AXIS T93F05/AXIS T93F10/AXIS T93F20
AXIS T93F Series
IEC 60721-4-3 Class 4M4
IEC 60529 IP66
NEMA 250 Type 4X
13