Charcoal Filter - Zanussi ZHC 9244 Notice D'utilisation

Charcoal filter

• The charcoal filter should only be used if you
want to use the hood in recirculation mode.
• To do this you will need an original charcoal
filter (available from your local Service Force
Centre).
• Cleaning/replacing the charcoal filter
Unlike other charcoal filters, the LONGLIFE
charcoal filter can be cleaned and reactivated.
With normal use the filter should be cleaned
every second month (when using the hood
2.5 hours per day,on avarage). The best way
to clean the filter is in the dishwasher. Use
normal detergent and choose the highest
temperature (65º C). Wash the filter
separately so that no food parts gets stuck on
the filter and later causes bad odours. To
reactivate the charcoal, the filter should be
dried in an oven for 10 minutes with a
maximum temperature of 100º C.
After approximately three years of use, the
charcoal filter should be replaced with a new
one, as the odour reduction capacity will be
reduced.
60
• Fitting
Remove the grease filters.
Remove the frame i which supports the filter
h by turning 90° the two knobs g.
Insert the charcoal filter inside the frame and
put all parts back in their place.
Refit the grease filters.
It is possible to use a traditional charcoal filter
(Type 15), neither washable nor regenerable, to
be replaced every 3 - 4 months.
The filter holder frame of the charcoal filter is
welded together; the eventual frame supplied
with the hood is not, therefore, to be used.
Insert it into its housing and fix it turning the 2
plastic knobs.
• To remove proceed in the reverse order.
• Always specify the hood model code number
and serial number when ordering replacement
filters. This information is shown on the rating
plate located on the inside of the unit.
• The charcoal filter can be ordered from your
local Service Force Centre.