Hapro LUXURA X10 Mode D'emploi page 9

Coin operated or stand alone:
The sunbed comes standard equipped for use with an external timer or a coin-op. To change this,
follow the steps below:
To access the coin-op, first open the configuration screen (key combination from left to right).
The 'main settings' menu now appears in the display.
Press 'Start' once Unit has been selected. This will open the sub-menu.
In the sub-menu select Start time
Now the scroll button can be used to change the setting to 0,1,2,3,4,5 etc.
5
0: coin-op activated
1-30: Stand alone
6
Press 'Start', the changes will be saved and the main menu reappears.
Press 'Stop', the changes will not be saved and the main menu reappears.
Operating in combination with an external timer or coin-op:
The sunbed will switch on automatically as long as the external or coin-op does not have a
'remote start'. If it does, then the sunbed must be switched on using the 'Start' button. If
necessary, your dealer can program this.
Pressing the 'Stop' button once will put the appliance on pause. If the 'Stop' button is pressed
more than once, the appliance will remain in pause mode. The sunbed will switch off once the
tanning time is up.
Note:
A . If the sunbed is switched on again less than three minutes after pressing
'Stop', the facial tanners may not switch on . These must cool off for three
minutes, after which time they will switch back on automatically .
B . Once the 'Stop' button is pressed, the air conditioning will continue runnin
for five minutes before switching off . The air conditioning also has a required
cooling period of three minutes once these five minutes are up .
C . The tanning time increases .
- 9 -