Technical Data; Motor; Mower; Sound Power Level - Sabo 32-EL Livret D'entretien

Insufficient overlapping
of cuts when mowing.
Lawn becomes matted.
Turbo signal has not
Ejection blocked
been detected
J + K .
Cutting height too low for
grass that is too high.
Pushing mower too fast.
Grass not dry.
Repairs to electrical machines must always be performed only by qualified electricians.
Please do not repair them yourself.
In the case of faults and defects which have not been listed here, please contact the
nearest authorized dealer. This applies in particular to appliances with electrical motors,
as when these are repaired they must always undergo an insulation protection test.
Your authorized dealer will also help you if you do not wish to perform any of the
maintenance work described here yourself.

18 TECHNICAL DATA

Motor

Motor
Connection voltage
Power
Motor speed

Mower

Housing
Cutting width
Cutting heights
Grass collector capacity
Weight
Length
Width
Height
Wheels front / rear
Bearing front / rear

Sound power level

Guaranteed sound power level;
measured according to 2000/14/EC

Sound pressure level

Emission sound pressure level at operator's workplace;
measured according to EN60335-2-77
Measuring inaccuracy; according to ISO 4871

Vibrations

Vibrations on the lawnmower's handlebar;
measured according to EN60335-2-77
Measuring inaccuracy; according to EN12096

19 ORIGINAL SPARE PARTS

Cutter bar
Tall grass conditions may
dictate that more overlapping
of cuts is required.
A lawn scarifier can remedy
the problem considerably
Empty the grass collector L .
Adjust to higher cutting height
I .
Adjust mowing speed.
Let grass dry.
Alternating current motor
230 V
1100 W
3000 min
Impact-resistant plastic (ABS)
320 mm
per axle, 25, 35, 45, 55, 65, 80 mm
32 litres
14,5 kg
1100 mm
385 mm
1025 mm
Ø 140 mm / Ø 140 mm
Sleeve bearing
L = 90 dB(A)
wa
L = 81 dB(A)
pA
3 dB
a = 1 m/s
hW
0.5 m/s
For safety reasons, the cutter bar must
always be replaced by an authorised
workshop.
This workshop has the respective spare
part numbers for the cutter bar available.
-1
2
2
9