Safety Precautions During Use; Main Edge Banding Machine Components (Fig. 1A); Edge Banding Machine Description (Fig. 1A) - Femi IB 500 Instructions Pour L'utilisation Et L'entretien

EN
Edge Banding Machine upkeep and maintenance:
- Always keep the handles and handgrips dry, clean and free from oil and grease.
- Always keep the tools in perfect condition. Keep tools sharp and clean to ensure maximum
performance and safety.
DANGER - WARNING
• THE USE OF ANY ACCESSORY OR CONNECTION DIFFERENT TO THOSE
INDICATED IN THIS MANUAL MAY LEAD TO THE RISK OF INJURY.
• DO NOT DISASSEMBLE THE EDGE BANDING MACHINE:
REPAIRS TO THE MACHINE MUST BE CARRIED OUT BY SKILLED PERSONNEL
ONLY. FAILURE TO OBSERVE THIS INDICATION COULD CREATE GRAVE
DANGER TO USERS.
DANGER - CAUTION
Always use original spare parts to guarantee correct and safe operation.
1.6.

SAFETY PRECAUTIONS DURING USE

Accident prevention warnings:
- It is absolutely forbidden to remove any waste material or parts of the workpiece from the
work area when the edge banding machine is running.
- Always keep hands well away from the operating area when the machine is in motion;
before performing any operation, release the stop button and wait for the tool to come to a
complete standstill.
- Before starting the edge banding machine always check that all the safety guards are
correctly installed and provide adequate tool protection.
- When working on very large pieces always use suitable side supports.
Precautions for use:
- Avoid to put the edge banding machine under mechanical stress: excessive pressure may
lead to rapid deterioration of the tool or decreased performance in terms of fi nish.
- Faulty switches must be replaced at an authorized after sales service centre.
- Only use the tools recommended in this manual.
- Check that the wrenches used for maintenance and adjustment operations have been
removed from the edge banding machine before starting it.
- Use only the edge banding machine's original blocking system.
- Replace any damaged parts.
1.7.

MAIN EDGE BANDING MACHINE COMPONENTS (FIG. 1A)

(1) Hot air gun
(2) Base
1.8.

EDGE BANDING MACHINE DESCRIPTION (FIG. 1A)

The edge banding machine is made up of two main parts: the hot air gun and the base.
16