Delayed Start; Cleaning The Outer Surfaces - Brandt BXP5556X Guide D'utilisation

COOKING FUNCTION
(depending on model)
TRADITIONAL
TRADITIONAL PULSE
CIRCULATING HEAT
PULSED BOTTOM
ECO
MEDIUM GRILL
FULL GRILL
GRILL PULSE
KEEP WARM
PIZZA
BOOST
4.4

DELAYED START

Proceed in the same way as for a programmed
time. After setting the cooking time, press
cooking end time
The display flashes. Set the cooking end time
with and .
The cooking end time is automatically saved after
a few seconds (or confirm by pressing the
button twice). The cooking end time display
stops flashing.
5

CLEANING THE OUTER SURFACES

Use a window washing product applied to a soft
cloth. Do not use abrasive creams or scouring
sponges.
PPYROLYSIS CLEANING
Before starting pyrolysis cleaning, remove any large
overspills, if any. Remove the excess grease on the
door using a damp sponge.
COOKING TIME RE-
COMMENDATION
30 min
30 min
30 min
30 min
30 min
10 min
7 min
15 min
60 min
15 min
5 min
flashes.
Cleaning
As a safety measure, cleaning only occurs after the
door locks automatically; it is impossible to unlock
the door.
Remove the accessories and supports
from the oven before beginning pyrolysis
cleaning.
5.1
REMOVING THE SHELF SUPPORTS
Lift the front part of the wire shelf support upwards.
Press the entire shelf support and release the front
hook from its housing. Then gently pull the whole
of the support towards you to release the rear
hooks from their housing. Pull out the two shelf
supports.
5.2
IMMEDIATE PYROLYSIS
> Pyro 2 hours,non modifiable (oven cooling time
not included)
> PyroExpress in 59 minutes.(oven cooling
time not included)
The PyroExpress function benefits from the heat
accumulated during the previous cooking session to
rapidly clean a slightly soiled oven using the
principles of pyrolysis, in under one hour, depending
on certain conditions.
PyroExpress is only possible if your oven
is still sufficiently hot, just after cooking. If
this is not the case, a 90-minute classic
pyrolysis cycle will automatically begin.
To activate pyrolysis, select the pyrolysis function of
; the
your choice. Confirm by pressing OK. The symbol
displays as well as the length of time for which
the oven will be unavailable.
The door is locked during pyrolysis; the symbol
will appear on the display. At the end of the cleaning
cycle, 0:00 will appear on the display and the door
will be unlocked.
DELAYED PYROLYSIS
Follow the instructions described in the
«immediate pyrolysis» paragraph and refer to
Chapter 4.4 delayed start to adjust the
pyrolysis end time.
After these steps have been completed, the
start of pyrolysis is delayed so that it finishes
at the programmed time.
5.3
CLEANING THE INSIDE GLASS
To make it easier to clean the inside glass, remove
the glass panels. Before doing this, remove any
excess grease with a soft cloth and washing up
liquid.
ENGLISH