MACHINE OPERATION
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Always check to ensure a vacuum bag is installed.
Replace bag if necessary (See Vacuum Bag
Removal/Installation).
ATTENTION: Never operate machine without a
filter bag in place, vacuum motor damage will
result.
2. Lower handle to operating position by depressing
handle release foot latch (Figure 2).
FIG. 2
3. Adjust brush height to suit carpet pile by turning
brush height adjustment knob on brush housing
(Figure 3).
NOTE: Handle MUST be disengaged from upright
position when adjusting brush for proper height.
FIG. 3
Magna Twin 1600/2200/2600 (10- -04)
Handle Release
Foot Latch
Brush Height
Ajustment Knob
Home Find... Go To..
4. Activate ON/OFF switch.
5. Operate by using normal vacuuming procedures,
and check vacuum bag periodically for fullness.
WARNING: Do Not Pick Up Flammable Or
Toxic Materials, Burning Or Smoking Debris.
6. For vacuuming under desks or other hard to reach
places, lower handle to stop point and depress
handle release foot latch once again. This enables
for further handle lowering (Figure 4).
FIG. 4
OPERATION
Depress Foot
Latch Again For
Further Lowering
13