Gb.4 Machine Components; Gb.5 Machine Installation; Gb.5.1 Machine Contents; Gb.5.2 Assembly Of The Suction Hose, Hand Tubes And Nozzle - Nobles Tidy-Vac 607961 Mode D'emploi

GB

GB.4 MACHINE COMPONENTS

1 Hose connector
2 Bent tube
3 Hand tube
4 Tank coupling
5 Nozzle
6 Cover
7 Handle
8 Opening spring
9 On/ Off switch
10 Power supply cord

GB.5 MACHINE INSTALLATION

GB.5.1 Machine contents
Carefully check carton for signs of damage. Report damages to carrier
immediately.
Check machine contents to ensure carton is complete. Contact
distributor for missing items.
Machine contents:
•
Tank
•
Cover with handle
•
Filter cartridge (inside tank)
•
Paper filter bag (inside tank)
•
Exhaust filter (pre-installed)
•
Hand tubes (two pieces)
•
Bent tube
•
Flexible suction hose
•
Nozzle.
(02-00)
Home Find... Go To..
Vacuum cleaner/ Aspirateur à poussière/ Aspiradora Tidy-Vac
GB.5.2 Assembly of the suction hose, hand
tubes and nozzle:
WARNING
Hazardous Voltage. Shock or electrocution can
result. Unplug machine before servicing.
•
Holding the rubber cuff of the suction hose coupling, insert it into
the tank coupling and rotate it clockwise.
•
Assemble the two hand tubes and bent tube by simply pushing
them together. Now fit the nozzle to the lower end of the hand
tubes and connect the end of the suction hose to the bent tube.
The length of the wand may be adjusted to suit the
Note:
operator. Simply remove the bent tube, turn it
around and reinsert it into the straight section .

GB.6 MACHINE SETUP

Ensure that the paper filter bag and filter cartridge are in the tank of the
machine and correctly positioned. Always ensure that filters are clean
and that the suction hose, wand and nozzle are not blocked.

GB.7 MACHINE OPERATION

FOR SAFETY:
Do not operate machine unless operator
manual is read and understood.
•
Connect the plug to the main supply and switch the machine on by
depressing the ON/OFF switch.
•
Begin vacuuming floor. Operate machine with a back and forth
motion.
•
Taking off wand and floor nozzle, the end of the flexible tube can
be used as a upholstery tool or crevice nozzle.
•
To stop vacuuming, switch the machine off by depressing the
ON/OFF switch.
•
Disconnect the plug from the main supply wall socket. Do not pull
on the cord as it may be damaged.
•
Always wind up the cord and hang it on the handle/cord hanger on
the top cover of the machine.
FOR SAFETY
: When using machine, do not unplug
by pulling on cord.

GB.8 STORING MACHINE

Store machine in a dry area.
Attention:
Do not expose to rain. Store indoors.
Keep out of the reach of children.

GB.9 MAINTENANCE ADVICE

GB.9.1 Regular maintenance
WARNING
Always disconnect the plug from the main supply
before commencing any cleaning or maintenance
of the machine. Always refer to the manufacturers
technical data and instructions when replacing any
parts.
5