Machine Setup; Machine Operation; Pre--Operation - Nobles POWER EAGLE 716 Manuel Opérateur

OPERATION

MACHINE SETUP

1. Carefully check carton for signs of damage.
Report damages at once to carrier. The machine
is shipped fully assembled and is ready for
operation.
2. Fill solution tank with 30.8L (7 gal) of hot water,
60°C (140°F) maximum (Figure 1).
NOTE: The water must not be hotter than 60_C
(140_F) or tank damage may occur.
NOTE: Use different buckets to fill and drain machine
to prevent solution system clogs.
FIG. 1
WARNING: Fire or Explosion Hazard. Never
Use Flammable Liquids.
3. Add a recommended cleaning solution. Follow
bottle's mixing instructions.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
ATTENTION: If using powdered cleaning
chemicals, mix prior to adding.
NOTE: If desired, hot water alone achieves excellent
cleaning results.
4. Close lid after filling.
8
Home Find... Go To..

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
WARNING: Fire Or Explosion Hazard. Never
Use Flammable Liquids Or Operate Machine in Or
Near Flammable Liquids, Vapors Or Combustible
Dusts.
PRE- -OPERATION
1. Vacuum carpet to remove particles and other
debris.
2. Inspect power cord for damage.
WARNING: Electrical Hazard. Do Not Operate
With Damaged Power Cord. Do Not Modify Plug.
Unplug power Cord Before Servicing Machine.
If the supply cord is damaged or broken, it must
be replaced by the manufacturer or it's service
agent or a similarly qualified person in order to
avoid a hazard.
3. Plug power cord into a grounded wall outlet
(Figure 2).
Grounded
3 Hole Outlet
Ground Pin
FIG. 2
FOR SAFETY: Do not operate machine with the
use of additional extension cords. Only use
manufacturer's extension cord equipped with
machine which has proper capacity and is
grounded.
Power Eaglet 716 (08- -05)