Other; Vacuum Motor; Storing Machine; Recommended Stock Items - Nobles MAGNA TWIN 1600 Manuel Opérateur Et Piéces

OPERATION
d. Rotate both bearing blocks 180_ and reinstall
brush (Figure 10).
NOTE: Brush bearing blocks are labeled with
numbers. To extend brush life, position label "2"
outwards when reinstalling brush.
Rotate
Bearing
Block
FIG. 10
e. Replace metal brush shoe after brush is properly
installed.

OTHER

1. Inspect vacuum hose regularly for holes, loose
cuffs or clogged debris.
2. Inspect rear door gasket regularly for leakage.
Replace if worn.
3. Clean vacuum housing with damp cloth and mild
soap.
16
Home Find... Go To..

VACUUM MOTOR

Check Vacuum Motor carbon brush wear every 250
hours of use. Replace carbon brush when worn to
3/8" (1cm) or less in length. Vacuum motor damage
due to carbon brush wear is not covered under
warranty.

STORING MACHINE

Before storing machine, neatly coil power cord, clean
or replace filters and install a new filter bag. Store
machine in a dry area.
WARNING: Do Not Use Outdoors Or On Wet
Surfaces. Do Not Expose to Rain. Store Indoors.

RECOMMENDED STOCK ITEMS

Refer to Parts List section for recommended stock
items. Stock Items are clearly identified with a bullet
preceding the parts description. See example below:
Magna Twin 1600/2200/2600 (10- -04)