Agrator ASR Manuel D'entretien Et D'utilisation page 12

Never allow PTO drive shift guards to fall into the implement or drop to the ground;
damage will almost certainly occur.
Always ensure the sliding surfaces of the guard tubes are clean and the guard bearings
lubricated.
When replacing worn or damaged sections of the guard, use special tools available from
the PTO shaft makers.
Always follow the fitting, lubrication and maintenance instructions supplied by the makers
of the PTO drive shaft guard.
UNLESS CORRECTLY GUARDED PTO DRIVE SHAFTS CAN KILL
Serial number
The serial and model number is stamped on the identification plate attached to your rotary
tiller. For future reference record the number below. ALWAYS quote them when ordering
spare parts.
SERIES REF. ...................................................................................
SERIAL NO .....................................................................................
DATE PURCHASED ..................................................................