Blade Replacement - Cembre B-TC950 Notice D'utilisation Et Entretien

4. BLADE REPLACEMENT

When changing blades, the battery must fi rst be removed from the tool.
After extended use, the blades may lose their cutting edge. Replace the blades as follows:
Lower blade
– Press lever (85) and open upper blade assembly.
– Operate tool to advance the lower blade (3) until holding screw (18) is visible on the ram (12),
than remove the battery from the tool.
– Using a fl at blade screwdriver remove the holding screw (18) and release the lower blade (3).
– Insert the new blade and fi t the holding screw.
Before closing the tool head, release the oil pressure and retract the lower blade, otherwise
the tool head assembly may hit and damage the lower blade.
Upper blade
– Press latch (85) and open upper blade assembly.
– Remove circlip (38) and pin (37).
– With a 13 mm spanner, undo M8 nuts (98) and remove two studs (99), blade guide (100) blade
spacer (101) and upper blade (48), noting the order of assembly.
– With a punch, drive out the split pin (102), collecting the spring (103) and the pin (97).
– Assemble the spring (103) and the pin (97) on the new blade, locking the whole by the split pin
(102).
– Fitting the new blade is a reversal of the above.
5. CONNECTION TO COMPUTER
The memory card integrated in the tool records operating data from 200.000 cycles for transfer via
the USB cable supplied.
To view and manage this data, go to www.cembre.com and register in the dedicated area, then
download the free Cembre software CEM_SWBT01.
Keeping the Firmware of the tool updated, via free of charge download from here, will optimise
the tool's performance.
– Following information applies in member states of the European Union:
USER INFORMATION in accordance with "Directives 2011/65/EU and 2012/19/EU.
The 'Not in the bin' symbol above when shown on equipment or packaging means that the equipment
must, at the end of its life, be disposed of separately from other waste.
The separate waste collection of such equipment is organised and managed by the manufacturer.
Users wishing to dispose of such equipment must contact the manufacturer and follow the prescribed
guidelines for its separate collection. Appropriate waste separation, collection, environmentally compat-
ible treatment and disposal is intended to reduce harmful environmental eff ects and promote the reuse
and recycling of materials contained in the equipment. Unlawful disposal of such equipment will be sub-
ject to the application of administrative sanctions provided by current legislation.
9
(Ref. to Fig. 7 page 30)