ECOVACS ROBOTICS DEEBOT N78 Mode D'emploi page 21

No. Malfunction
DEEBOT returns
to the Charging
4
Dock before it
finishes cleaning.
DEEBOT
will not clean
5
automatically at
scheduled time.
Remote Control
failure (effective
6 control range of
Remote Control
is 5m/16').
Possible Causes
When battery power gets low,
DEEBOT automatically switches
to Return to Charger Mode and
returns to the Charging Dock to
recharge itself.
Working time varies according
to floor surface, room complexity
and the selected Cleaning Mode.
Intelligent Scheduling function is
cancelled.
DEEBOT is powered OFF.
the robot's battery is low.
the robot's Suction Intake is
blocked and/or its components
are tangled with debris.
The battery in the Remote
Control need to be replaced.
DEEBOT is powered OFF or the
robot's battery is low.
The infrared signal cannot be
transmitted because the Infrared
Emitter on Remote Control or the
Infrared Receiver on DEEBOT is
dirty.
There is other equipment
interfering with the infrared signal
to DEEBOT.
5. Troubleshooting
Solutions
This is normal. No solution necessary.
This is normal. No solution necessary.
Set Intelligent Scheduling. Please refer
to section 3.4 Intelligent Scheduling for
details.
Power ON DEEBOT.
Keep DEEBOT powered ON and on
the Charging Dock to make sure it has
full battery to work at any time.
Power OFF DEEBOT, clean
the Dust Bin and invert the robot.
Clean the Suction Intake and Side
Brushes as described in section 4
Maintenance.
Replace with a new battery making
sure it is installed correctly.
Make sure DEEBOT is powered ON
and fully charged.
Use clean dry cloth or the brush side of
the provided Multi-Function Cleaning
Tool to wipe the Infrared Emitter on
Remote Control and the Infrared
Receiver on DEEBOT.
Avoid using the Remote Control near
other equipment using infrared signals.
19
EN