Cleaning Mode Selection - ECOVACS ROBOTICS DEEBOT N78 Mode D'emploi

3.3 Cleaning Mode Selection

DEEBOT has several Cleaning Modes to choose from to effectively clean different floors.
Cleaning Modes are selected with the Remote Control.
AUTO Cleaning Mode
1
This is the most commonly used mode. In
AUTO Cleaning Mode, DEEBOT cleans in
a straight line and changes direction when it
meets an obstacle.
Spot Cleaning Mode
3
(2-5 minutes)
This mode is applicable for an area of highly
concentrated dirt or dust. In Spot Cleaning
Mode, DEEBOT focuses on a specific area
to clean. DEEBOT cleans the area in a spiral
pattern and stops when it completes Spot
Cleaning.
3. Operating and Programming
Edge Cleaning Mode
2
This mode is good for cleaning the edges
and corners of a room. In Edge Cleaning
Mode, DEEBOT cleans along a border (e.g.
wall) and returns to the Charging Dock when
it completes Edge Cleaning.
Return to Charger Mode
4
When battery power gets low, DEEBOT
automatically switches to Return to Charger
Mode and returns to the Charging Dock to
recharge itself.
DEEBOT can also be sent back to the
*
Charging Dock at any time by pressing
the Return to Charger Button on the
Remote Control.
11
EN