Télécharger Imprimer la page

Trouble Shooting/Error Conditions; Error Message; Corrective Action - Warn Zeon Platinum Guide D'utilisation

De la télécommande sans fil évoluée

Publicité

Les langues disponibles

Les langues disponibles

8. If pairing was unsuccessful, repeat steps 1-5.
9. To close the pairing panel, press Select.
Thermal Protection Setting
Your Advanced Wireless Remote has a thermal
protection setting, giving you the option to have
the winch shut off automatically when it reaches a
high temperature protection point.
1. To activate the thermal protection setting,
navigate to the thermal Icon and press Select.
Thermal
protection
Icon
Select
2. The thermal protection system defaults as
deactivated.
protection
deactivated
3. To activate the thermal protection setting, use
the left or right button to highlight the thermal
protection shut-off option. A check mark will
appear in the box. Press select to confirm
selection.
FIRST TIME OPERATING INSTRUCTIONS
Thermal
Thermal
protection
activated
WARN INDUSTRIES
21
TROUBLESHOOTING

Trouble Shooting/Error Conditions

Problem
Winch is not
operating
Remote controlled
clutch does not
disengage when
requested
Remote will not
operate
Auxiliary will not
turn on
Auxiliary short
circuit
Wireless signal
strength is low
92821A3
92821A3

Error Message

Possible cause
Low wireless strength
Wireless Remote
Control Activation
Switch is in the OFF
position
Winch control pack is
under water. Wireless
signal will not transmit
under water.
Tension or Load
exists on the winch,
preventing the clutch
from disengaging.
The remote controlled
clutch is disconnected
from the control pack.
The remote controlled
clutch is damaged.
The remote battery is
critically low.
Auxiliary is not
connected
Accessories wiring
faulty; Accessory
electrical load is
to high. *Auxiliary
systems must be rated
for 12v and draw less
than 16 amps.
WARN INDUSTRIES
22

Corrective action

Make sure your Advanced
Wireless Remote Control is
within range.
Turn ON the Wireless Remote
Control Activation Switch
Winch control pack needs
to be above water to receive
wireless signal. See www.
warn.com for accessories.
Power-out winch until winch
rope is no longer under load.
Check the 4-pin remote
controlled clutch connector
on the back of the control
pack to be sure it is fi rmly
connected.
Contact WARN® customer
service for further information.
Charge the remote battery
See charging instructions on
page 13.
Check auxiliary connector and
cables.
Check wiring; reduce electrical
load.
Decrease distance between
remote control and winch.

Publicité

loading

Ce manuel est également adapté pour:

95960