Operation - ophelis CN Serie Dokumentation Technique / Mode D'emploi

Operation

1. Reset at first start-up
A reset is required the first time the desk is used before
the desk can be used in the normal manner. All desk
columns are set to the same height at the desk's middle
position.
2. Reset
To carry out a reset press the UP and DOWN buttons on
the manual switch simultaneously until the desk starts
to move and reaches its middle position. Press both
buttons for another 4 seconds.
The anti-collision device is inactive during all reset
activities. Please be aware of a potential crushing
hazard!
16 ophelis Technical Documentation and Operating Instructions for CN Series Sitting-Standing Tables
Fig. Manual switch
3. Factory setting (only for Memory function)
To reset the memory control unit to its factory settings,
simultaneously press position button 1, 2 and the UP
button and hold for 3 seconds until the display shows
S and a number. Then press the UP button until the
display shows S0 and confirm with the memory button.
Remark: the settings for container stop and shelf stop
will be lost.
4. Manual desk height adjustment
· Press the UP button to raise the desk.
· Press the DOWN button to lower the desk.
· The motors continue to move for as long as you press
the button or until the maximum desk height has been
reached.