Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Features
Power-on duration monitoring
The power-on duration monitoring checks how long the table col-
umns have been moving. After 2 minutes of uninterrupted use, the
control unit will switch off automatically for 18 minutes to prevent
overheating – „HOT" will appear on the display.
Safety shutdown
The control unit will shut down automatically when components
become too hot. The system will automatically return to operation
after the components have cooled down sufficiently.
Safety zone
The safety range starts 40 mm before the tabletop reaches its
lowest position. This feature causes the system to stop before the
tabletop reaches its lowest position. It requires the user to press
the DOWN button again to continue lowering the desk to the lowest
position at a reduced speed.
Programmable position (only ap-
A total of four positions can be saved.
plicable for manual switch with
memory function)
Drive back
When a safety feature (e.g. collision detection) is triggered, the
desk will automatically be driven back in the opposite direction by
approx. 30 mm to prevent crushing injury.
Overload detection
The control unit is able to detect excessive loads (weight) on the
table and switch off automatically.
Softstart / Softstop
After starting and before stopping, the drive units will run briefly
at a reduced speed so that the tabletop can gently start and stop
moving.
ControlBasic
Manual switch port HS
1
Installation holes
2
Actuator port M1
3
Actuator port M2
4
5
Power port PWR
1
2
3
18
4
2
5
Operation
Fig. Manual switch
DesignBase-Down
1
Connector cable
2
UP button
3
DOWN button
Fig. Manual switch with memory function
Connector cable
1
2
MENU button
3
MEMORY buttons F1-F4
4
UP button
5
DOWN button
6
EXIT button
7
Display
ophelis Technical documentation and operating instructions for CL Series sitting-standing workplaces
1
2
3
2
1
3
6
7
4
5
19
Publicité
Table des Matières
