Maintenance; Warranty - Dru 64CB Installation Et Mode D'emploi

5. Maintenance

It takes little effort to keep your stove in good condition.
Regularly check whether the sealing cord still closes the doors tightly enough.
The painted or enamelled cast iron mantle can be cleaned with a moist, soft cloth, when
it is almost cold. Make sure no aggressive, acid products get in touch with enamelled
parts.
Minor paint damage can be touched up with a can of spray paint. Your dealer can supply
you with the correct spray product. For enamel damage, small repair kits of appropriate
colour are available from your dealer.
During the first use after repainting your unit might give off some slight odour.
However, this will disappear quickly.
The glass can be cleaned with a number of glass cleaning products available from your
dealer. Your installer can also supply you with appropriate products. However, never use
abrasive or corrosive cleaning products.
T o c lean the air ducts, you may remove the top plate; it lies loosely on the stove and is
not attached with screws or bolts.
At the end of the heating season, seal off the chimney with a ball of paper. You can then
thoroughly clean the stove on the inside.
If necessary, replace the sealing ropes and use fire cement to fill up possible leaks.
Remove the fire plate for better and more thorough cleaning. Eventually remove the
refractory stones first.
You should have your chimney swept by an expert before the heating season begins. It
is also useful to check the chimney for soot during the heating season and to check for
blockage of the chimney flue prior to re -lighting after a prolonged shut down period.
Checking and maintaining the chimney is a statutory requirement.
When all of the above advice is heeded, you will be able to fully enjoy your stove.

6. Warranty

The warranty for your DRU stove will be provided by your supplier. If you have any
complaints you should always contact him.
Your supplier will contact DRU should he consider this to be necessary.
The factory warranty is valid for 7 years after the date of purchase, with the following
exceptions:
2 years:
moving parts (hinges, slides, door closing system, etc.)
vitreous enamel
6 months for combustibles, i.e. parts exposed directly to heat or flames, e.g.:
fire bricks, or wall or bottom of combustion chamber
baffle plate
glass
sealants
DRU 64CB - DRU 78CB
34
03.27616.000