Low Heating (For Devices Suitable For Continuous Use); Ash Removal; Extinguishing The Fire; Weather Conditions - Dru 64CB Installation Et Mode D'emploi

Masquer les pouces Voir aussi pour 64CB:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.5.

Low heating (for devices suitable for continuous use)

To use the device as a 'continuous fire', you can select the primary and secondary air
scoops in such a way you get the right burning speed. Always make sure there's enough
glow on the heating bottom.
4.6.

Ash removal

The bottom of the fire compartment is equipped with a port to eliminate the ashes.
Open the port (see picture) and sweep the redundant ashes into the ashtray by means of
the scraper. With the "cold handle", you can pull the ashtray from the stove (see picture).
Relatively speaking, burning wood produces little ash and it will not be necessary to
remove it each time daily. The ash in the cavities between the ribs of the fire plate does
not need to be removed, since wood burns better on a bed of ash.
4.7.

Extinguishing the fire

Stop fuelling the fire and let it burn out.
Damping a fire by closing the air slides involves the release of noxious gases. You
should let the fire burn out and keep an eye on it as long as it is still glowing.
4.8.

Weather conditions

Attention!
Mist and heavy fog will block the chimney's fume outlet and may lead to smoke
emission into the living room.
It is best not to use the stove under these weather conditions.
DRU 64CB - DRU 78CB
33
03.27616.000

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

78cb

Table des Matières