Switching The Remote Control Id - Yamaha RX-497 Mode D'emploi

ADVANCED SETUP
3
Press the preset station/channel number
buttons (1 and 2) on the front panel
repeatedly to move through the menu and
select the parameter you want to adjust.
See page 35 for a complete list of available
parameters.
4
Press A/B/C/D/E on the front panel
repeatedly to toggle between the available
parameters.
5
Press MASTER ON/OFF to release it outward
to the OFF position to confirm your setting.
MASTER
ON
Note
The settings you made are reflected next time you turn on the
power of this unit.
36
1 2
A/B/C/D/E
CATEGORY
OFF

Switching the remote control ID

You can select the unit you want to operate with the
remote control by switching the remote control ID.
1
Press and hold CODE SET on the remote
control and then press TUNER on the remote
control.
CODE SET
MENU
2
While holding down CODE SET on the
remote control, use the numeric buttons on
the remote control to enter the three-digit
code number listed in the table below.
CODE SET
MENU
Remote
control ID*
(this unit's
setting)
To operate this
ID1
alternative code.
To operate this
ID2
(default setting)
* When you change the remote control ID, you must switch
the remote control ID of this unit (see page 35).
When using multiple YAMAHA receivers or
amplifiers with the same default code setting, you
may unwantedly operate those components
simultaneously. In this case, set one of the alternative
codes for this unit to operate this unit separately.
Note
Also change the remote control ID of the Zone 2 remote control
(sold separately) (see page 9).
POWER
POWER POWER STANDBY
TV AV
CD MD/TAPE TUNER XM
DVD DTV/CBL VCR PHONO
1 2 3 4
5 6 7 8
9 0 10 ENT.
TITLE MENU
BAND SRCH MODE
ENTER
A-E/CAT. A-E/CAT.
RETURN DISPLAY
MEMORY
PRESET/CH
Function Code number
unit using an
801
unit using the
802
default code.