Radio reception
Problem
Too much noise during
stereo broadcast.
Even with an outdoor antenna,
radio wave reception is weak.
(Sound is distorted.)
Remote control
Problem
The remote control does not
work properly.
■ PLAYER SECTION
iPod
• Supported iPod .............iPod (5th generation), iPod classic,
• Supported iPhone ..............iPhone, iPhone 3G, iPhone 3GS
AUX IN
• Input connector
............ STEREO L/R: 3.5 mm (1/8 in) STEREO mini jack
■ AMPLIFIER SECTION
• Maximum output power .......................... 4 W + 4 W + 8 W
• Driver unit ...................4 cm (1 5/8 in) full-range driver × 2
5.5 cm (2 1/8 in) woofer + SR-Bass × 1
■ TUNER SECTION
• Tuning range
FM ...................................................87.50 to 107.90 MHz
AM ......................................................... 530 to 1710 kHz
Cause
The antenna may be connected
improperly.
The radio station you selected may be far
from your area, or the radio wave
reception is weak in your area.
Multipath reflection or other radio
interferences may have occurred.
Cause
The remote control may be operated
outside its operation range.
The remote control sensor on the unit
may be exposed to direct sunlight or
lighting (inverted fluorescent lamps).
The battery may be worn out.
There are obstacles between the sensor of
the unit and the remote control.
SPECIFICATIONS
■ GENERAL
• Power supply ........................................... AC 120 V, 60 Hz
• Power consumption .....................................................10 W
• System off consumption .............................................1.2 W
iPod nano, iPod touch
• Standby consumption...................................... 1.0 W or less
• Dimensions (W × H × D)......................260 × 90 × 141 mm
• Weight......................................................... 1.2 kg (2.6 lbs.)
Specifications are subject to change without notice.
iPod™, iPhone™
(6 Ω 1 kHz, 10% THD)
iPod is a trademark of Apple Inc., registered in the U.S. and
other countries.
iPhone is a trademark of Apple Inc.
"Made for iPod" means that an electronic accessory has been
designed to connect specifically to iPod and has been
certified by the developer to meet Apple performance
standards.
"Works with iPhone" means that an electronic accessory has
been designed to connect specifically to iPhone and has been
certified by the developer to meet Apple performance
standards.
Apple is not responsible for the operation of this device or its
compliance with safety and regulatory standards.
SPECIFICATIONS
Solution
Make sure the antenna is connected
properly (☞ P. 3).
Try manual tuning to improve the signal
quality (☞ P. 7) or use a multi-channel
outdoor antenna.
Change the height, direction, or placement
of the antenna.
Solution
For information on the remote control
operation range, refer to "Using the remote
control" (☞ P. 1).
Change the lighting or orientation of the
unit.
Replace the battery with a new one (☞ P. 1).
Remove the obstacles.
(10 1/4 × 3 1/2 × 5 1/2 in)
9
En