Initial Operation; Computer-Configuration; Asio Driver Installation; Windows - Reloop MIXAGE Interface Edition MK2 Mode D'emploi

2. INItIaL OpEratION

The device is automatically supplied with electrical current as soon as a USB connection to a
computer has been set up. Connect the included USB cable to the corresponding port -B39- on the
device's rear panel and a free USB port of your computer.
3. COMputEr CONFIGuratION
Before you can use your new device a few basic computer adjustments have to be carried out.
attENtION!
please make sure that your reloop Mixage is turned off (disconnect the uSB cable -B39-). You
will be asked during the installation to turn on the device respectively connect the uSB cable.
please especially observe the following explanations.

3.1. aSIO drIvEr INStaLLatION

In order for the audio signals to be sent quickly to the device, so called ASIO drivers are necessary.
Depending on the operating system in use, different steps are necessary to carry out the installation.

3.1.1. WINdOWS

Insert the included installation CD into your CD drive. In the file „Audio Drivers" select the driver
setup and start the installation with a double click.
tIp!
reloop regularly provides updated drivers online. For more information please read the chapter
„updates & Support".
NOtE!
please make sure to start the driver installation with admin rights. Otherwise the installation
will fail with an error message.
If you use Windows Vista or Windows 7 please carry out the installation setup via a click of the
right mouse button followed by the selection „Run as admin".
1. At first a welcome window will appear. Simply press „Next".
24